eobdTOOL

Confusing finding a auto key programmer?

Want to know more about XTOOL classic products? Which is the best sale? What should be noticed? Which one should choose?

XTOOL EZ500 HD Heavy Duty Diagnostic:

http://www.xtooleshop.com/wholesale/xtool-ez500-hd-heavy-duty-diagnosis-system-with-special-function.html

Fault diagnosis: With XTOOL EZ500 HD detector detection, the engine control module (ECM) stored in the fault code P2118, meaning the throttle actuator (throttle motor) current range / performance failure. As shown in Figure 1, the throttle control system has a dedicated power supply circuit (powered by the fuse ETCS).

When the voltage on the ECM terminal + BM is below 4V, the ECM determines that the throttle control system is faulty Store the fault code P2118. When the ECM detects that the throttle control system is faulty, the EZ500 Heavy Duty enters the fail-safe mode.

XTOOL X100 PAD2 with VW 4^TH 5^TH IMMO:

http://www.xtooleshop.com/wholesale/x-100-pad2-expert-with-vw-4th-5th-immo.html

In the fail-safe mode, the XTOOL pad2 cuts off the current flowing to the throttle actuator, and the throttle retains a fixed opening (6 °) under the action of the return spring; then the ECM controls the fuel injection (intermittent fuel cut) according to the accelerator pedal position sensor signal )

And the ignition timing to adjust the engine output power to ensure that the vehicle to maintain the minimum speed, then gently depress the accelerator pedal, the vehicle can travel slowly. The sensor circuit is tested with an xtool x100 pad2 pro lamp or a high impedance meter (eg digital millimeter).

The ignition switch should be turned off (OFF) when XTOOL EZ500 HD disassembling or installing the inductive sensor to prevent its self-induced electromotive force from damaging the ECU and generating new faults.

XTOOL EZ500 Full-System Diagnostic Tool:

http://www.xtooleshop.com/wholesale/xtool-ez500-full-system-diagnosis-for-gasoline-vehicles.html

The basic contents of the electronic control engine inspection are still the inspection of the oil circuit, the ez500 and the sealing property (especially the sealing of the air intake system). The EZ500 Full-System reflects the failure of the electronic control system and the parts which are affected by the work, So the X100 Pad2 VW IMMO analysis and the relevant parameters are the basis for judging the fault.

XTOOL X100 Pro Auto Key Programmer

Troubleshooting: first test. Turn on the ignition switch. Oil pressure warning light for the red light state. Start and run the engine, the warning light goes out, light again after half a minute, and it turns yellow. This is XTOOL X100 Pro repeated several times. Turn off the engine. Pull out the oil dipstick check the oil volume, normal. Connect the GTl diagnostic device for self-diagnosis, select the 3 Series E46 chassis models, click on the "quick test" button, the entire vehicle electronic control system to scan. When finished, click the right arrow key twice. Enter xtool x100 pro auto key programmer, you can see in the "KOM combination instrument" project.

If you want to find more XTOOL Brand tool, please turn to:

http://www.xtooleshop.com/

Or you could see some entries about XTOOL:

http://blog.xtooleshop.com/