eobdTOOL

Adjust the rear trouble, order replacement headlamp control module. It is necessary to Launch X431 V 8 inch talet remind here, Mercedes-Benz LED headlamp control module, whether it is to upgrade or replace the new control module need to use special tools to scan the bumper on the two-dimensional code and bar code, headlamp control module is scanned bar code, The LED control module is scanning the two-dimensional code. In front of already said, LED headlamps are launch x431 controlled through the channel, different channels occupy the light function is not the same, you must scan the relevant two-dimensional code and bar code to distinguish between different channels, so as to the Secretary of the Job. But here you can tell us a little skill, 4S station with a CGDI Prog Mercedes Benz dedicated scanning tool is very expensive, we can use the phone under a special scanning software, the same can be swept inside the information, but sweep out A large number of CGDI Prog numbers, put it inside the box on the line.
    Fault Summary: In fact, this is a relatively simple fault cases, to figure out the functional principle is very simple, and each fault has the characteristics of each fault, but we must clarify the mystery, which solve the problem Only targeted. I think x431  through this failure we understand the new S-class full-LED headlamps and some of the diagnostic principles of diagnostic methods, this is the most important point.

Opel Opcom v1.95 reviews:

Although this is a brilliant bit of kit for all Vauxhalls. BE WARNED, this wont work properly for Corsa C as you will get continuous looping (Okay for all other Vauxhalls cars though). Sellers are selling these with a 1.44 or 1.45 Firmware and saying its the latest. Yes that Firmware is the latest but the Software that comes with it has not been updated for that Firmware when its used on the Corsa C. The only way round this is to get the 1.39 Firmware (which is actually the best available) and flash the interface so that its running on 1.39 Firmware. Not for the fainthearted though as doing it wrong will damage the interface. If you have a Corsa C then look for Opcom with 1.39 Firmware. If you have any other car in the Vauxhall range then any of the Firmwares will work perfectly. Its just Firmware 1.44 or 1.45 that will not work as it should with the Corsa C.